How to replace the scissors mechanism/frame on Pride VivaLift recliners

The metal scissors mechanism and frame are one piece on all Pride VivaLift recliner chairs. Replacing either item replaces both.  Follow these steps:

1. Remove back of chair from base by pushing in clips and lifting off.
2. Place the chair base in sitting (non-lift/non reclined) position.
3. Turn the base of the chair upside down so that the chair seat cushion is resting on the floor. You may want to do this on a bedsheet or blanket so that the chair seat doesn't get dirty.
4. Remove a total of 10 screws: 4 Black 7/16" screws that fasten the frame/scissors to the seat and six fastening frame to the footrest. 
5. Disconnect all wires and zip ties connected to lift frame and control box
6. Remove the motors from the frame and install on the new frame using existing hardware. Replace zip ties with new ones or tape as needed. 
7. Replace the ten screws fastening the sides and footrest.
8. Turn the chair base right-side up and reinstall the seat back.

These instructions do not apply to other Pride Mobility brand lift recliners.

This information is primarily for servicers, but a customer could perform this work.